arpschuino.fr

1.2.3 that was. This has some nice upgrades allready. Seems to hold up for now, will report what happens later in venues.. I see a Homing option in this software, that offcourse has to do with a zero of full switch. But just sharing a thought here, now when the board resets for whatever reason the p...

I am using the arpschuino32, I am on the Holy Motors firmware 1.3.2? I thought of RDM, But to my knowledge I was not outputting RDM in MA3 (you have to set the ports to RDM out, should do that with normal DMX out settings. But that would be a major difference between MA3 and HOG. Going to upgrade to...

Hello, Recently ran into a problem. I've been touring with the same setup for 1,5 year now, using Arpschuino to control 6 stepper motors. Working flawlessly. Until now.. The board seems to reset randomly. I swapped out the boards and power supply without any succes, Power seens fine also because I c...

Hello, For a project I am making small pulleys with steppermotors. Currently I have an Arpscuino with two arp>breadboard so I can use 8 steppermotors with separate drivers. Now I would like to use one channel that controls a relay, wich powers a solenoid (elektro/magnet). This solenoid will blok the...